Ford 2002 Escape v.2 Manuel d'utilisateur télécharger pdf (Page 106)

Programming remote transmitters

It is necessary to have all (maximum of four — original and/or new) of

your remote transmitters available prior to beginning this procedure.

To program the transmitters yourself:

• Insert a key in the ignition and

turn from 1 (LOCK) to 3 (RUN)

eight times in rapid succession

(within 10 seconds) with the

eighth turn ending in the 3

(RUN) position. The doors will

lock/unlock to confirm that

programming mode has been

entered.

• Within 20 seconds, program a

remote transmitter by pressing

any button on a transmitter. The doors will lock/unlock to confirm that

the remote transmitter has been programmed. (If more than 20

seconds pass before pressing a remote transmitter button, the

programming mode will exit and the procedure will have to be

repeated.)

• Repeat the previous step to program additional remote transmitters.

The doors will lock/unlock to confirm that each remote transmitter has

been programmed.

• When you have completed programming the remote transmitters, turn

the ignition to 1 (LOCK) or wait 20 seconds. Again the doors will

lock/unlock to confirm programming has been completed.

Illuminated entry

The interior lamps illuminate when the remote entry system is used to

unlock the door(s).

The system automatically turns off after 30 seconds or when the ignition

is turned to the RUN position. The dome lamp control (if equipped)

must not be set to the OFF position for the illuminated entry system to

operate.

Locks and Security

106

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 279 280

Pas de commentaire

Ford 2002 Escape v.2 Manuel d'utilisateur Page 106