Ford 2011 Transit Connect v.2 Manuel d'utilisateur télécharger pdf (Page 76)

1. Insert a previously programmed

coded key into the ignition.

2. Turn the ignition from the 0 (off)

position to the II (on) position.

Keep the ignition in the II (on)

position for at least one second, but

no more than 10 seconds.

3. Turn the ignition to the 0 (off)

position.

4. Remove the previously programmed coded key from the ignition.

5. After three seconds but within 10 seconds of removing the previously

programmed coded key, insert the other previously programmed coded

key into the ignition.

6. Turn the ignition from the 0 (off) position to the II (on) position.

Keep the ignition in the II (on) position for at least one second but not

more than 10 seconds.

7. Turn the ignition to the 0 (off) position.

8. Remove the previously programmed coded key from the ignition.

9. After three seconds but within twenty seconds of removing the

previously programmed coded key, insert the unprogrammed key

(new/valet key) into the ignition.

10. Turn the ignition from the 0 (off) position to the II (on) position.

Keep the ignition in the II (on) position for at least one second, but no

more than 10 seconds.

11. Your new, unprogrammed key is now programmed.

If the key has been successfully programmed it will start the vehicle’s

engine and the theft indicator light will illuminate for three seconds and

then go out.

If the key was not successfully programmed, it will not start your

vehicle’s engine and the theft indicator light will flash on and off, or stay

on for more than three seconds. If failure repeats, bring your vehicle to

your authorized dealer to have the new key(s) programmed.

To program additional new unprogrammed key(s), repeat this procedure

from Step 1 for each additional key.

Locks and Security

2011 Transit Connect (tst)

Owners Guide, 2nd Printing

USA (fus)

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 294 295

Pas de commentaire

Ford 2011 Transit Connect v.2 Manuel d'utilisateur Page 76