Ford 2011 Transit Connect v.2 Manuel d'utilisateur télécharger pdf (Page 249)

If the vehicle’s engine or transmission has just been serviced, or the

battery has recently run down or been replaced, the OBD-II system may

indicate that the vehicle is not ready for I/M testing. To determine if the

vehicle is ready for I/M testing, turn the ignition key to the on position

for 15 seconds without cranking the engine. If the service engine

soon

indicator blinks eight times, it means that the vehicle is not

ready for I/M testing; if the service engine soon indicator stays on

solid, it means that the vehicle is ready for I/M testing.

The OBD-II system is designed to check the emission control system

during normal driving. A complete check may take several days. If the

vehicle is not ready for I/M testing, the following driving cycle consisting

of mixed city and highway driving may be performed:

15 minutes of steady driving on an expressway/highway followed by

20 minutes of stop-and-go driving with at least four 30-second idle

periods.

Allow the vehicle to sit for at least eight hours without starting the

engine. Then, start the engine and complete the above driving cycle. The

engine must warm up to its normal operating temperature. Once started,

do not turn off the engine until the above driving cycle is complete. If

the vehicle is still not ready for I/M testing, the above driving cycle will

have to be repeated.

Maintenance and Specifications

249

2011 Transit Connect (tst)

Owners Guide, 2nd Printing

USA (fus)

1 2 ... 244 245 246 247 248 249 250 251 252 253 254 ... 294 295

Pas de commentaire

Ford 2011 Transit Connect v.2 Manuel d'utilisateur Page 249