Ford 2011 Transit Connect v.2 Manuel d'utilisateur télécharger pdf (Page 182)

WARNING: Objects that are close to either corner of the

bumper or under the bumper, might not be seen on the screen

due to the limited coverage of the camera system.

WARNING: Back up as slow as possible since higher speeds

might limit your reaction time to stop the vehicle.

WARNING: Do not use the camera system with the rear doors

open.

If the back end of the vehicle is hit or damaged, then check with your

authorized dealer to have your rear view camera checked for proper

coverage and operation.

Night time and dark area use

At night time or in dark areas, the camera system relies on the reverse

lamp lighting to produce an image. Therefore, it is necessary that both

reverse lamps are operating in order to get a clear image in the dark. If

either of the lamps are not operating, stop using the camera system, at

least in the dark, until the lamp(s) are replaced and functioning.

Servicing

• If the image comes on while the vehicle is not in R (Reverse), have

the system inspected by your authorized dealer.

• If the image is not clear, then check if there is anything covering the

lens such as dirt, mud, ice, snow, etc. If the image is still not clear

after cleaning, have your system inspected by your authorized dealer.

BLIND SPOT MIRRORS

Blind spot mirrors have an integrated convex spotter mirror built into

the upper outboard corner of the outside mirrors. They are designed to

assist the driver by increasing visibility along the side of the vehicle. For

more information on your side view mirrors, refer to Exterior mirrors in

the Driver Controls chapter.

Driving

182

2011 Transit Connect (tst)

Owners Guide, 2nd Printing

USA (fus)

1 2 ... 177 178 179 180 181 182 183 184 185 186 187 ... 294 295

Pas de commentaire

Ford 2011 Transit Connect v.2 Manuel d'utilisateur Page 182