Ford 2010 Flex v.1 Manuel d'utilisateur télécharger pdf (Page 89)

100

101

Replacing rear stop/park/turn/backup and side marker lamp bulbs

(non LED)

The stop/tail/turn/backup and side marker lamp bulbs are located in the

tail lamp assembly.

Note: Your vehicle may be equipped with a stop/park/turn and side

marker lamp assemblies containing integral multiple light emitting diodes

(LED). If replacement is required, see your authorized dealer.

• (1) Backup lamp

• (2) Stop/park/turn signal lamp

• (3) Side marker lamp

• (4) Supplemental taillamp

1. Make sure the headlamp switch is

in the off position and open the

liftgate.

2. Remove the hex screws in the

liftgate opening, then pull the lamp

assembly away from the vehicle. This will disengage two snap

attachments along the side of the vehicle.

3. Remove the bulb socket by rotating it counterclockwise, then pulling it

out of the lamp assembly.

4. Pull the bulb straight from the socket.

Install new bulb(s) in reverse order.

Replacing license plate lamp bulbs

1. Make sure the headlamp switch is

in the off position.

2. Remove the two screws from the

license plate lamp assembly and pull

it down.

3. Carefully pull the bulb out from

the contacts.

Install new bulb(s) in reverse order.

Lights

2010 Flex (471)

Owners Guide, 1st Printing

USA (fus)

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 396 397

Commentaires sur ces manuels

Pas de commentaire

Ford 2010 Flex v.1 Manuel d'utilisateur Page 89

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2010 Flex v.1