Ford 2010 Flex v.1 Manuel d'utilisateur télécharger pdf (Page 86)

Note: The ambient lights will stay on until the ignition is placed in the

off position and either of the front doors are opened or the accessory

delay timer expires.

BULB REPLACEMENT

Lamp assembly condensation

Exterior lamps are vented to accommodate normal changes in pressure.

Condensation can be a natural by-product of this design. When moist air

enters the lamp assembly through the vents, there is a possibility that

condensation can occur when the temperature is cold. When normal

condensation occurs, a thin film of mist can form on the interior of the

lens. The thin mist eventually clears and exits through the vents during

normal operation. Clearing time may take as long as 48 hours under dry

weather conditions.

Examples of acceptable condensation are:

• Presence of thin mist (no streaks, drip marks or droplets)

• Fine mist covers less than 50% of the lens

Examples of unacceptable moisture (usually caused by a lamp water

leak) are:

• Water puddle inside the lamp

• Large water droplets, drip marks or streaks present on the interior of

the lens

Take your vehicle to dealer for service if any of the above conditions of

unacceptable moisture are present.

Using the right bulbs

Replacement bulbs are specified in the chart below. Headlamp bulbs

must be marked with an authorized “D.O.T.” for North America and an

“E” for Europe to ensure lamp performance, light brightness and pattern

and safe visibility. The correct bulbs will not damage the lamp assembly

or void the lamp assembly warranty and will provide quality bulb burn

time.

Lights

2010 Flex (471)

Owners Guide, 1st Printing

USA (fus)

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 396 397

Pas de commentaire

Ford 2010 Flex v.1 Manuel d'utilisateur Page 86