Ford 2007 Freestar v.2 Manuel d'utilisateur télécharger pdf (Page 111)

1. Insert the first previously

programmed coded key into the

ignition and turn the ignition from

the 3 (OFF) position to the 4 (ON)

position [maintain ignition in 4 (ON)

for at least three seconds, but no

more than ten seconds].

2. Turn ignition from the 4 (ON)

position back to the 3 (OFF)

position in order to remove the first

coded key from the ignition.

3. Within ten seconds of removing the first coded key, insert the second

previously programmed coded key into the ignition and turn the ignition

from the 3 (OFF) position to the 4 (ON) position [maintain ignition in

the 4 (ON) position for at least three seconds but no more than ten

seconds].

4. Turn the ignition from the 4 (ON) position back to the 3 (OFF)

position in order to remove the second coded key from the ignition.

5. Within 10 seconds of removing the second coded key, insert the new

unprogrammed key (new key/valet key) into the ignition and turn the

ignition from the 3 (OFF) position to the 4 (ON) position [maintain

ignition in the 4 (ON) position for at least three seconds, but no more

than ten seconds]. This step will program your new key to a coded key.

6. To program additional new unprogrammed key(s), repeat this

procedure from step 1.

If successful, the new coded key(s) will start the vehicle’s engine and the

theft indicator will illuminate for three seconds and then go out.

If not successful, the new coded key(s) will not start the vehicle’s engine

and the theft indicator will flash on and off and you may repeat Steps 1

through 5. If failure repeats, bring your vehicle to your authorized dealer

to have the new spare key(s) programmed.

2007 Freestar (win)

Owners Guide (post-2002-fmt)

USA (fus)

Locks and Security

111

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 319 320

Pas de commentaire

Ford 2007 Freestar v.2 Manuel d'utilisateur Page 111