Ford 2007 Freestar v.2 Manuel d'utilisateur télécharger pdf (Page 106)

The system will automatically turn off if:

• the vehicle is locked using the remote entry system, the keyless entry

keypad, or

• the ignition is turned to the 4 (ON) position, or

• after 25 seconds of illumination.

Deactivating/activating perimeter lamps

You may enable/disable this feature by having your vehicle serviced by

your authorized dealer.

You may also perform the following power door lock sequence to

enable/disable the perimeter lamps feature:

1. Turn the ignition to the 4 (ON) position, then press the power door

unlock control 3 times.

2. Turn the ignition to the 3 (OFF) position, then press the power door

unlock control 3 times.

3. Turn the ignition to 4 (ON) position. Completing the sequence within

30 seconds enters a program mode and is confirmed by a horn chirp.

Activating or deactivating perimeter lighting once in program mode is

accomplished by:

• Pressing the power door unlock control twice within five seconds. At

this point, perimeter lighting will be activated if it was previously

deactivated, and deactivated if it was previously activated.

Confirmation of perimeter lighting being activated is provided by a

short horn chirp followed by a long horn sound; Confirmation of

perimeter lighting being deactivated is provided by a short horn chirp

only.

• Exiting the program mode is accomplished by turning the ignition to

any position other than the 4 (ON) position, or two minutes elapsing

since the program mode was entered.

Note: The puddle lamps cannot be deactivated. Performing this

deactivation procedure will only deactivate the head, park and tail lamps.

For information regarding perimeter lamps delay, refer to Autolamps -

Programmable exit delay in the Lights chapter.

2007 Freestar (win)

Owners Guide (post-2002-fmt)

USA (fus)

Locks and Security

106

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 319 320

Pas de commentaire

Ford 2007 Freestar v.2 Manuel d'utilisateur Page 106