Ford 2004 Taurus v.3 Manuel d'utilisateur télécharger pdf (Page 220)

manufactured, the next two are the tire size code and the last four

numbers represent the week and year the tire was built. For example,

the numbers 317 mean the 31st week of 1997. After 2000 the numbers

go to four digits. For example, 2501 means the 25th week of 2001. The

numbers in between are marketing codes used at the manufacturer’s

discretion. This information is used to contact customers if a tire defect

requires a recall.

9. M+S or M/S: Mud and Snow. or

AT: All Terrain. or

AS: All Season.

10. Tire Ply Composition and Material Used: Indicates the number of

plies or the number of layers of rubber-coated fabric in the tire tread and

sidewall. Tire manufacturers also must indicate the ply materials in the

tire and the sidewall, which include steel, nylon, polyester, and others.

11. Maximum Load: Indicates the maximum load in kilograms and

pounds that can be carried by the tire. Refer to the tire label or the

safety certification label, located on the B-Pillar or the driver’s door, for

the correct tire pressure for your vehicle

12. Treadwear, Traction and Temperature Grades

• Treadwear: The treadwear grade is a comparative rating based on the

wear rate of the tire when tested under controlled conditions on a

specified government test course. For example, a tire graded 150

would wear one and one-half (1

⁄

) times as well on the government

course as a tire graded 100.

• Traction: The traction grades, from highest to lowest are AA, A, B,

and C. The grades represent the tire’s ability to stop on wet pavement

as measured under controlled conditions on specified government test

surfaces of asphalt and concrete. A tire marked C may have poor

traction performance.

• Temperature: The temperature grades are A (the highest), B and C,

representing the tire’s resistance to the generation of heat and its

ability to dissipate heat when tested under controlled conditions on a

specified indoor laboratory test wheel.

13. Maximum Permissible Inflation Pressure: Tire manufactures

maximum permissible pressure and/or the pressure at which the

maximum load can be carried by the tire. This pressure is normally

higher than the manufacturer’s recommended cold inflation pressure

which can be found on either the tire label or certification label which is

located on the structure by the trailing edge of the driver’s door or the

edge of the driver’s door. The cold inflation pressure should never be set

lower than the recommended pressure on the vehicle label.

2004 Taurus (tau)

Owners Guide (post-2002-fmt)

USA English (fus)

Maintenance and Specifications

220

1 2 ... 215 216 217 218 219 220 221 222 223 224 225 ... 247 248

Commentaires sur ces manuels

Pas de commentaire

Ford 2004 Taurus v.3 Manuel d'utilisateur Page 220

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2004 Taurus v.3