Ford 2004 Taurus v.3 Manuel d'utilisateur télécharger pdf (Page 44)

Replacing tail/brake/turn signal/backup lamp bulbs

Sedan

The tail lamp, brake lamp, turn

signal lamp and backup lamp bulbs

are located in the same portion of

the tail lamp assembly. Follow the

same steps to replace either bulb.

1. Make sure headlamp switch is in

OFF position and open trunk and

remove two plastic mushroom nuts,

five push pins and the plastic cover

from inside the trunk to access the

lamp assembly.

2. Carefully pull the carpet away to

expose the lamp assembly hardware.

3. Remove three nut and washer

assemblies and the lamp assembly

from the vehicle.

4. Remove the bulb socket by

rotating it counterclockwise, then

pulling it out of the lamp assembly.

5. Pull the bulb from the socket and

push in the new bulb.

6. Install the bulb socket into the

lamp assembly by rotating it

clockwise.

7. Install the lamp assembly on the vehicle with three nut and washer

assemblies ensuring the washers on the nuts are flush with the body to

prevent water from entering the trunk.

8. Carefully push the carpet back in to place and install the plastic cover

inside the trunk with five push pins and two plastic mushroom nuts.

2004 Taurus (tau)

Owners Guide (post-2002-fmt)

USA English (fus)

Lights

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 247 248

Pas de commentaire

Ford 2004 Taurus v.3 Manuel d'utilisateur Page 44