Ford 2004 Taurus v.3 Manuel d'utilisateur télécharger pdf (Page 106)

3. For the seating position being disabled, buckle then unbuckle the safety

belt 9 times, ending in the unbuckled state. (Step 3 must be completed

within 50 seconds after the safety belt warning light turns off.)

• After step 3, the restraint system warning light (airbag light) will be

turned on for three seconds.

4. Within 10 seconds of the light turning on, buckle then unbuckle the

safety belt.

• This will disable the BeltMinder feature for that seating position if it is

currently enabled. As confirmation, the restraint system warning light

will flash 4 times per second for 3 seconds.

• This will enable the BeltMinder feature for that seating position if it is

currently disabled. As confirmation, the restraint system warning light

will flash 4 times per second for 3 seconds, followed by 3 seconds with

the light off, then followed by the restraint system warning light

flashing 4 times per second for 3 seconds again.

Safety belt extension assembly

If the safety belt is too short when fully extended, there is a 20 cm

(8 inch) safety belt extension assembly that can be added (part number

611C22). This assembly can be obtained from your dealer at no cost.

Use only extensions manufactured by the same supplier as the safety

belt. Manufacturer identification is located at the end of the webbing on

the label. Also, use the safety belt extension only if the safety belt is too

short for you when fully extended.

Do not use extensions to change the fit of the shoulder belt

across the torso.

Safety belt maintenance

Inspect the safety belt systems periodically to make sure they work

properly and are not damaged. Inspect the safety belts to make sure

there are no nicks, tears or cuts. Replace if necessary. All safety belt

assemblies, including retractors, buckles, front seat belt buckle

assemblies, buckle support assemblies (slide bar-if equipped), shoulder

belt height adjusters (if equipped), shoulder belt guide on seatback (if

equipped), child safety seat LATCH and tether anchors, and attaching

hardware, should be inspected after a collision. Ford Motor Company

recommends that all safety belt assemblies in use in vehicles involved in

a collision be replaced. However, if the collision was minor and a

2004 Taurus (tau)

Owners Guide (post-2002-fmt)

USA English (fus)

Seating and Safety Restraints

106

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 247 248

Pas de commentaire

Ford 2004 Taurus v.3 Manuel d'utilisateur Page 106