Ford 2003 Windstar v.2 Manuel d'utilisateur télécharger pdf (Page 81)

Replacing the battery

The remote entry transmitter uses one coin type three-volt lithium

battery CR2032 or equivalent. The typical operating range for your

remote entry transmitter is approximately 10 meters (33 feet). A

decrease in the operating range could be caused by:

• weather conditions,

• nearby radio towers,

• structures around the vehicle and

• other vehicles parked next to the vehicle.

To replace the battery:

1. Twist a thin coin between the two

halves of the remote entry

transmitter near the key ring. DO

NOT TAKE THE FRONT PART OF

THE REMOTE ENTRY

TRANSMITTER APART.

2. Remove the old battery.

3. Insert the new battery. Refer to

the diagram inside the remote entry

transmitter for the correct orientation of the battery.

4. Snap the two halves back together.

Note: Replacement of the battery will not cause the remote transmitter

to become deprogrammed from your vehicle. The remote transmitter

should operate normally after battery replacement.

Replacing lost remote entry transmitters

If you would like to have your remote entry transmitter reprogrammed

because you lost one, or would like to buy additional remote entry

transmitters, you can either reprogram them yourself, or take all

remote entry transmitters to your authorized dealer for

reprogramming.

How to reprogram your remote entry transmitters

You must have all remote entry transmitters (maximum of four)

available before beginning this procedure.

Locks and Security

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 239 240

Pas de commentaire

Ford 2003 Windstar v.2 Manuel d'utilisateur Page 81