Ford 2003 Windstar v.2 Manuel d'utilisateur télécharger pdf (Page 198)

relearn its idle and fuel trim strategy for optimum driveability and

performance. To begin this process:

1. With the vehicle at a complete stop, set the parking brake.

2. Put the gearshift in P (Park), turn off all accessories and start the

engine.

3. Run the engine until it reaches normal operating temperature.

4. Allow the engine to idle for at least one minute.

5. Turn the A/C on and allow the engine to idle for at least one minute.

6. With your foot on the brake pedal and with the A/C on, put the

vehicle in D (Drive) and allow the engine to idle for at least one minute.

7. Drive the vehicle to complete the relearning process.

• The vehicle may need to be driven 16 km (10 miles) or more to

relearn the idle and fuel trim strategy.

• If you do not allow the engine to relearn its idle trim, the idle

quality of your vehicle may be adversely affected until the idle

trim is eventually relearned.

If the battery has been disconnected or a new battery has been installed,

the clock and the preset radio stations must be reset once the battery is

reconnected.

If the battery has been discharged, disconnected or a new battery has

been installed, the power sliding door may need to be reset. Refer to

Power Sliding Door-Resetting the PSD in the Controls and Features

chapter.

• Always dispose of automotive

batteries in a responsible manner.

Follow your local authorized

standards for disposal. Call your

local authorized recycling center

to find out more about recycling

automotive batteries.

ENGINE COOLANT

Checking engine coolant

The concentration and level of engine coolant should be checked at the

mileage intervals listed in the scheduled maintenance guide. The coolant

RECYCLE

Maintenance and Specifications

198

1 2 ... 193 194 195 196 197 198 199 200 201 202 203 ... 239 240

Pas de commentaire

Ford 2003 Windstar v.2 Manuel d'utilisateur Page 198