Ford 2003 Windstar v.2 Manuel d'utilisateur télécharger pdf (Page 52)

• disconnecting the battery

• if the PSD fuse (fuse #6) is removed or blown. Refer to Fuses and

relays in the Roadside emergencies chapter.

If any of the above conditions has occured, preform the following steps

to reset the PSD:

1. Check to see if PSD is unlocked and securely closed.

2. Make sure the gearshift is in (P) Park.

3. Push the PSD control on the overhead console to open the door.

4. Wait five (5) seconds and close the door by pressing the PSD control

on the overhead console.

5. Wait five (5) seconds and repeat Steps 3 and 4 then go on to step 6.

6. Repeat steps 3–5 for opposite door.

If the door does not rest in the fully open position, repeat Steps 1–4

again. If the door still does not operate correctly:

7. Turn the ignition switch to OFF.

8. Remove the PSD fuse (fuse #6) from the passenger fuse panel and

leave it out for thirty (30) seconds. Refer to Fuses and relays in the

Roadside emergencies chapter.

9. Reinstall the fuse and wait ten (10) seconds.

10. Repeat steps 1–6 above.

If the door still does not operate correctly, see your dealer for service.

Sliding Door Child Safety Lock

Your vehicle is equipped with a sliding door child safety lock that helps

prevent passengers from operating the sliding door by using the inside

door handle, refer to Child safety locks in the Locks and Security

chapter.

To open the sliding door when the child safety lock is on:

• Unlock the sliding door and open the door from the outside.

• Press the right or left hand control on the overhead console to open

the door.

AUXILIARY POWER POINT

Power outlets are designed for accessory plugs only. Do not hang

any type of accessory or accessory bracket from the plug.

Improper use of the power outlet can cause damage not covered

by your warranty.

Driver Controls

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 239 240

Pas de commentaire

Ford 2003 Windstar v.2 Manuel d'utilisateur Page 52