Ford 2003 F-150 v.3 Manuel d'utilisateur télécharger pdf (Page 89)

• If two previously programmed coded keys are not available, you must

take your vehicle to your dealer to have the spare key(s)

programmed.

1. Insert a previously programmed

coded key into the ignition.

2. Turn the ignition from the 1

(OFF) position to the 3 (ON)

position. Keep the ignition in the 3

(ON) position for at least one

second, but no more than 10

seconds.

3. Turn the ignition to the 1 (OFF)

position.

4. Remove the previously programmed coded key from the ignition.

5. Within ten seconds of removing the previously programmed coded key,

insert the other previously programmed coded key into the ignition.

6. Turn the ignition from the 1 (OFF) position to the 3 (ON) position.

Keep the ignition in the 3 (ON) position for at least one second but not

more than 10 seconds.

7. Turn the ignition to the 1 (OFF) position.

8. Remove the previously programmed coded key from the ignition.

9. Within twenty seconds of removing the previously programmed coded

key, insert the unprogrammed key (new/valet key) into the ignition.

10. Turn the ignition from the 1 (OFF) position to the 3 (ON) position.

Keep the ignition in the 3 (ON) position for at least one second, but no

more than 10 seconds.

11. Your new, unprogrammed key is now programmed.

If the key has been successfully programmed it will start the vehicle’s

engine and the theft indicator light will illuminate for three seconds and

then go out.

If the key was not successfully programmed, it will not start your

vehicle’s engine and the theft indicator light will flash on and off, or stay

on for more than three seconds. If failure repeats, bring your vehicle to

your dealer to have the new key(s) programmed.

To program additional new unprogrammed key(s), repeat this procedure

from step 1 for each additional key.

Locks and Security

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 279 280

Pas de commentaire

Ford 2003 F-150 v.3 Manuel d'utilisateur Page 89