Ford 2003 F-150 v.3 Manuel d'utilisateur télécharger pdf (Page 170)

If a distance of 80 km (50 miles) or a speed of 56 km (35 mph) must be

exceeded, the drive shaft will have to be removed before the vehicle is

towed.

Ford recommends the driveshaft be removed/installed only by a qualified

technician. See your local dealer for driveshaft removal/installation.

Improper removal/installation of the driveshaft can cause

transmission fluid loss, damage to the driveshaft and internal

transmission components.

4WD vehicles electronic shift transfer case:

4x4 vehicles with electronic shift on the fly cannot be towed with any

wheels on the ground.

SNOWPLOWING

Ford recommends the following specifications for low speed, personal

use snow removal:

• F-150 4x4 (except F-150 Supercrew, Lightning and Harley-Davidson

models)

• 5.4L engine

• Heavy-duty service package

• Super engine cooling

• Heavy-duty front suspension package

• Automatic transmission with auxiliary automatic transmission fluid

cooling

• All-terrain tires

• Limited slip and optional axle ratio.

Do not install a snowplow and plow with your vehicle until it has been

driven at least 800 km (500 miles).

Installing the snowplow

Read the following instructions before installing a snowplow:

• Front GAWR must not exceed 63% of the GVW. Add ballast weight to

the back of the vehicle, if necessary. Refer to the Safety Compliance

Certification Label to find your vehicle’s front GAWR.

• The Front Axle Accessory Reserve Capacity and the TARC listed on

the bottom right of the Safety Compliance Certification Label will

determine whether or not the addition of a snowplow will overload

your vehicle.

Driving

170

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 279 280

Pas de commentaire

Ford 2003 F-150 v.3 Manuel d'utilisateur Page 170