Ford 2003 F-150 v.3 Manuel d'utilisateur télécharger pdf (Page 68)

1. Press and hold the two outside

buttons releasing only when the red

light begins to flash after 20

seconds. Do not repeat step one to

program additional hand-held

transmitters to the remaining two

HomeLink威 buttons. This will erase

previously programmed hand-held

transmitter signals into HomeLink威.

2. Position the end of your hand-held transmitter 2–8cm(1–3 inches)

away from the HomeLink威 Universal Transceiver surface (located on

your visor) while keeping the red light in view.

3. Simultaneously press and hold

both the HomeLink威 and hand-held

transmitter button. Do not release

the buttons until step 4 has been

completed.

Some entry gates and garage door

openers may require you to replace

step 3 with procedures noted in the

“Gate Operator and Canadian Programming” section for Canadian

residents.

4. The red light will flash slowly and then rapidly. Release both buttons

when the red light flashes rapidly. (The rapid flashing light indicates

acceptance of the hand-held transmitters’ radio frequency signals.)

5. Press and hold the just-trained HomeLink威 button and observe the red

light. If the light is a constant red, programming is complete and your

device should activate when the HomeLink威 button is pressed and

released. Note: To program the remaining two HomeLink威 buttons,

begin with step 2 in the “Programming” section — do not repeat step 1.

If the red light blinks rapidly for two seconds and then turns to a

continuous red, proceed with steps 6 through 8 to complete

programming of a rolling code equipped device.

6. At the garage door opener receiver (motor-head unit) in the garage,

locate the “learn” or “smart” button (usually near where the hanging

antenna wire is attached to the unit).

7. Press and release the “learn” or “smart” button. (The name and color

of the button may vary by manufacturer.)

Note: There are 30 seconds in which to initiate step eight.

REC DEL PLAY

Driver Controls

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 279 280

Pas de commentaire

Ford 2003 F-150 v.3 Manuel d'utilisateur Page 68