Ford 2003 Explorer Sport Trac v.3 Manuel d'utilisateur télécharger pdf (Page 148)

Before changing the tire:

1. Park on a level surface.

2. Activate the hazard flashers.

3. Place the gearshift lever in P (Park) (automatic transmission) or R

(Reverse) (manual transmission).

4. Set the parking brake.

5. Turn off the ignition.

To change the tire:

Note: Passengers should not remain in the vehicle when the vehicle is

being jacked.

1. Block both the front and rear of

the wheel diagonally opposite the

flat tire. For example, if the right

front tire is flat, block the left rear

wheel.

2. Remove any wheel trim by inserting the flat end of the lug nut wrench

under the wheel trim flange, then twisting the wrench to pry it off.

3. Loosen, but do not remove, the

wheel lug nuts by turning them

one-half turn counterclockwise.

Slide the jack handle and jack

handle extension together. Slide the

jack handle assembly into the end of

the lug nut wrench. To disconnect,

depress the button and pull the pieces apart.

4. Position the jack properly and insert the jack handle into the opening

in the thumbwheel at the base of the jack. Turn the handle clockwise

until the tire is a maximum of 25 mm (1 inch) off the ground.

Roadside Emergencies

148

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 215 216

Pas de commentaire

Ford 2003 Explorer Sport Trac v.3 Manuel d'utilisateur Page 148