Ford 2014 Fusion v.3 Manuel d'utilisateur télécharger pdf (Page 74)

HEADLAMP EXIT DELAY

After you switch the ignition off, you can

switch the headlamps on by pulling the

direction indicator lever toward you. You

will hear a short tone. The headlamps will

switch off automatically after three

minutes with any door open or 30 seconds

after the last door has been closed. You

can cancel this feature by pulling the

direction indicator toward you again or

switching the ignition on.

DAYTIME RUNNING LAMPS (IF

EQUIPPED)

WARNING

Always remember to switch your

headlamps on in low light situations

or during inclement weather. The

system does not activate the tail lamps

and may not provide adequate lighting

during these conditions. Failure to activate

your headlamps under these conditions

may result in a collision.

The system switches the low beam

headlamps on at a reduced intensity in

daylight conditions.

To switch the system on, switch the

ignition on, and switch the lighting control

to the off, autolamp or parking lamp

position.

AUTOMATIC HIGH BEAM

CONTROL (IF EQUIPPED)

The system will automatically turn on your

high beams if it is dark enough and no other

traffic is present. When it detects the

headlights of an approaching vehicle, the

tail lamps of the preceding vehicle or street

lighting, the system will turn off the high

beams before they distract other drivers.

The low beams remain on.

Note: If it appears that automatic control

of the high beams is not functioning

properly, check the windshield in front of

the camera for a blockage. A clear view of

the road is required for proper system

operation. Have any windshield damage in

the area of the camera’s field-of-view

repaired.

Note: If the system detects a blockage such

as bird droppings, bug splatter, snow or ice,

and you do not observe changes, the system

will go into low beam mode until you clear

the blockage. A message may also appear

in the instrument cluster display noting the

front camera is blocked.

Note: Typical road dust, dirt and water

spots will not affect the performance of the

automatic high beam system . However, in

cold or inclement weather conditions, you

will notice a decrease in the availability of

the high beam system, especially at start

up. If you want to change the beam state

independently of the system, you may

switch the high beams on or off using the

multifunction switch. Automatic control will

resume when conditions are correct.

Note: Modification of the vehicle ride height

such as using much larger tires, may

degrade feature performance.

A camera sensor, centrally mounted

behind the windshield of your vehicle,

continuously monitors conditions to decide

when to switch the high beams off and on.

71

Fusion (CC7) , enUSA

Lighting

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 457 458

Commentaires sur ces manuels

Pas de commentaire