Ford 2014 Fusion v.3 Manuel d'utilisateur télécharger pdf (Page 62)

Anti-Scan Feature

The keypad will go into an anti-scan mode

if you enter the wrong code seven times

(35 consecutive button presses). This

mode disables the keypad for one minute

and the keypad lamp will flash.

The anti-scan feature will turn off after:

• one minute of keypad inactivity

• pressing the unlock button on the

remote control

• switching the ignition on

• unlocking your vehicle using intelligent

access.

Unlocking and Locking the Doors

To Unlock the Driver Door

Enter the factory-set 5-digit code or your

personal code. You must press each

number within five seconds of each other.

The interior lamps will illuminate.

Note: All doors will unlock if you enable the

all-door unlocking mode. See Locking and

Unlocking (page 54).

To Unlock All Doors

Enter the factory-set code or your personal

code, then press 3·4 within five seconds.

To Lock All Doors

Press and hold 7·8 and 9·0 at the same

time (with the driver door closed). You do

not need to enter the keypad code first.

To Release the Trunk

Enter the factory-set code or your personal

code, then press 5·6 within five seconds.

Displaying the Factory Set Code

With Integrated Keyhead Transmitters

Note: You will need to have two

programmed passive anti-theft keys for this

procedure.

To display the factory-set code in the

information display:

1. Insert a key into the ignition and switch

the ignition on for a few seconds.

2. Switch the ignition off and remove the

key.

3. Insert the second key into the ignition

and switch the ignition on.

The factory-set code will display for a few

seconds.

Note: The code may not display until after

any other warning messages first display.

With Intelligent Access Keys

Note: You will need to have two

programmed intelligent access keys for this

procedure.

To display the factory-set code in the

information display:

E147165

1. Place the first programmed key in the

backup slot inside the center console.

The key ring must be at the top with

the buttons facing toward the rear.

2. Press the START/STOP button once

and wait a few seconds.

3. Press the START/STOP button again

and remove the key.

4. Insert the second programmed key into

the backup slot, then press the

START/STOP button.

59

Fusion (CC7) , enUSA

Locks

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 457 458

Commentaires sur ces manuels

Pas de commentaire