Ford 2011 E-450 v.1 Manuel d'utilisateur télécharger pdf (Page 53)

7. On the wall or screen, locate the high intensity area of the beam

pattern. The left edge of the high intensity area should be even with the

vertical line corresponding to the headlamp under adjustment. If the left

edge of the high intensity area is not even with the vertical line, follow

the next step to adjust it.

8. Locate the horizontal adjuster (2) for each headlamp. Turn it

clockwise or counterclockwise, to place the left edge of the high

intensity area even with the vertical line corresponding to the headlamp

under adjustment.

VERTICAL AIM ADJUSTMENT (AERODYNAMIC HEADLAMPS)

The headlamps on your vehicle can only be vertically adjusted. Your

vehicle does not require horizontal aim adjustments.

To adjust the headlamps:

1. Park the vehicle directly in front of a wall or screen on a level surface,

approximately 25 feet (7.6 meters) away.

• (1) 8 feet (2.4 meters)

• (2) Center height of lamp to

ground

• (3) 25 feet (7.6 meters)

• (4) Horizontal reference line

2. Measure the height from the

center of your headlamp (indicated

by a 3.0 mm circle on the lens) to

the ground and mark an 8 foot

(2.4 meter) horizontal reference line

on the vertical wall or screen at this height (a piece of masking tape

works well).

3. Turn on the low beam headlamps to illuminate the wall or screen and

open the hood. Cover one of the headlamps so no light hits the wall.

4. On the wall or screen you will

observe a light pattern with a

distinct horizontal edge towards the

right. If this edge is not at the

horizontal reference line, the beam will need to be adjusted so the edge

is at the same height as the horizontal reference line.

Lights

2011 Econoline (eco)

Owners Guide, 1st Printing

USA (fus)

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 336 337

Pas de commentaire

Ford 2011 E-450 v.1 Manuel d'utilisateur Page 53