Ford 2010 Ranger v.2 Manuel d'utilisateur télécharger pdf (Page 65)

How to reprogram your remote entry transmitters

You must have all remote entry transmitters (maximum of four)

available before beginning this procedure.

Note: Ensure the brake pedal is not

pressed during this sequence.

To reprogram the remote entry

transmitters:

1. Ensure the vehicle is

electronically unlocked.

2. Put the key in the ignition.

3. Turn the key from the 2 (lock)

position to 3 (off).

4. Cycle eight times rapidly (within 10 seconds) between the 3 (off)

position and 4 (on). Note: The eighth turn must end in the 4 (on)

position.

5. The doors will lock, then unlock, to confirm that the programming

mode has been activated.

6. Within 20 seconds press any button on the remote entry transmitter.

Note: If more than 20 seconds have passed you will need to start the

procedure over again.

7. The doors will lock, then unlock, to confirm that this remote entry

transmitter has been programmed.

8. Repeat Step 6 to program each additional remote entry transmitter.

9. Turn the ignition to the 3 (off) position after you have finished

programming all of the remote entry transmitters. Note: After

20 seconds, you will automatically exit the programming mode.

The doors will lock, then unlock, to confirm that the programming mode

has been exited.

Illuminated entry

The interior lamps illuminate when the remote entry system is used to

unlock the door(s) or sound the personal alarm.

The illuminated entry system will turn off the interior lights if:

• the ignition switch is turned to the on position, or

• the remote transmitter lock control is pressed, or

• after 25 seconds of illumination.

Locks and Security

2010 Ranger (ran)

Owners Guide, 2nd Printing

USA (fus)

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 286 287

Pas de commentaire

Ford 2010 Ranger v.2 Manuel d'utilisateur Page 65