Ford 2010 Ranger v.2 Manuel d'utilisateur télécharger pdf (Page 177)

To start the vehicle:

1. Make sure the parking brake is

fully set.

2. Press and hold the clutch pedal

to the floor, then put the gearshift

lever in the neutral position.

3. Start the engine.

4. Press the brake pedal and move

the gearshift lever to the desired

gear; 1 (First) or R (Reverse).

5. Release the parking brake, then

slowly release the clutch pedal while

slowly pressing on the accelerator.

During each shift, the clutch pedal

must be fully pressed to the floor.

Make sure the floor mat is properly

positioned so it doesn’t interfere

with the full extension of the clutch

pedal.

Failure to fully press the clutch pedal to the floor may cause

increased shift efforts, prematurely wear transmission

components or damage the transmission.

Do not drive with your foot resting on the clutch pedal or use the

clutch pedal to hold your vehicle at a standstill while waiting on a

hill. These actions will severely reduce the life of the clutch and

could nullify a clutch warranty claim.

Recommended shift speeds

Upshift and downshift according to the following charts:

Upshifts when accelerating (for best fuel economy)

Shift from:

Transfer case position (if equipped)

2H or 4H 4L

1 - 2 10 mph (14 km/h) 4 mph (5 km/h)

2 - 3 22 mph (32 km/h) 9 mph (11 km/h)

3 - 4 33 mph (50 km/h) 13 mph (19 km/h)

4 - 5 (Overdrive) 41 mph (71 km/h) 17 mph (27 km/h)

Driving

177

2010 Ranger (ran)

Owners Guide, 2nd Printing

USA (fus)

1 2 ... 172 173 174 175 176 177 178 179 180 181 182 ... 286 287

Pas de commentaire

Ford 2010 Ranger v.2 Manuel d'utilisateur Page 177