Ford 2010 Edge v.1 Manuel d'utilisateur télécharger pdf (Page 65)

• (1) 8 feet (2.4 meters)

• (2) Center height of lamp to

ground

• (3) 25 feet (7.6 meters)

• (4) Horizontal reference line

2. Measure the height of the

headlamp bulb center from the

ground and mark an 8 foot

(2.4 meter) horizontal reference line

on the vertical wall or screen at this

height (a piece of masking tape works well).

3. Turn on the low beam headlamps to illuminate the wall or screen and

open the hood.

To see a clearer light pattern for adjusting, you may want to block the

light from one headlamp while adjusting the other.

4. There is a distinct cut-off (change

from light to dark) in the left

portion of the beam pattern. The

top edge of this cut-off should be

positioned two inches (50.8 mm)

below the horizontal reference line.

5. Locate the vertical adjuster on

each headlamp. Using a Phillips #2

screwdriver, turn the adjuster either

clockwise (to adjust down) or

counterclockwise (to adjust up).

The horizontal edge of the brighter

light should touch the horizontal

reference line.

6. Close the hood and turn off the lamps.

HORIZONTAL AIM IS NOT REQUIRED FOR THIS VEHICLE AND IS

NON-ADJUSTABLE.

Lights

2010 Edge (edg)

Owners Guide (own2002), 1st Printing

USA (fus)

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 327 328

Pas de commentaire

Ford 2010 Edge v.1 Manuel d'utilisateur Page 65