Ford 2010 Edge v.1 Manuel d'utilisateur télécharger pdf (Page 228)

If the fuse is not blown and the brakelamps are working properly, the

following procedure will allow you to move the gearshift lever from P

(Park):

1. Apply the parking brake, turn the

ignition key to the off position, and

remove the key.

2. Using a screwdriver (or similar

tool), carefully pry off and remove

the chrome trim ring (1) from the

shifter base.

3. Open the storage compartment

lid and carefully pry the trim panel

(2) up from rear attachments on the

storage compartment and disconnect it from the console.

4. Locate the brake shift interlock

lever on the passenger side of the

shifter assembly.

5. Apply the brake pedal. Using a

screwdriver (or similar tool), press

and hold the brake shift interlock

lever while pulling the gearshift

lever out of the P (Park) position

and into the N (Neutral) position.

6. Install the trim panel (2) and

chrome ring (1) in reverse order.

7. Apply brake pedal, start the vehicle, and release the parking brake.

See your authorized dealer as soon as possible if this procedure

is used.

WARNING: Do not drive your vehicle until you verify that the

brakelamps are working.

WARNING: Always set the parking brake fully and make sure

the gearshift is latched in P (Park). Turn the ignition to the off

position and remove the key whenever you leave your vehicle.

Driving

228

2010 Edge (edg)

Owners Guide (own2002), 1st Printing

USA (fus)

1 2 ... 223 224 225 226 227 228 229 230 231 232 233 ... 327 328

Pas de commentaire

Ford 2010 Edge v.1 Manuel d'utilisateur Page 228