Ford 2005 Escape v.4 Manuel d'utilisateur télécharger pdf (Page 61)

Installing a garage door opener (if equipped)

The storage compartment can be converted to accommodate a variety of

aftermarket garage door openers:

• Remove the VELCRO威 pad (2)

from the storage compartment

door (3).

• Place VELCRO威 (5) on

aftermarket transmitter (6)

opposite of actuator control (8).

• Measure the thickness (4) of the

aftermarket transmitter (6).

• Remove the rubber actuator (1)

from the storage compartment

(7) by pulling the rubber actuator

(1) forward and twisting at the

same time.

Note: The length of the rubber

actuator (1) is critical. Use care

in cutting it to length. If the rubber

actuator (1) is cut too much the

aftermarket transmitter (6) will not

activate the garage door opener. If

the rubber actuator (1) is cut too

long, the storage compartment door (3) will not close properly.

Excessive force to close the storage compartment door (3) may cause

the door latch to break.

• Per the table below, cut the rubber actuator (1) to the proper length

based on the thickness (4) measured in the third step.

Approximate Thickness of Transmitter (GDO)

inches mm Cut to Bottom of Notch

Less Than

1/4 6.35 No Cut

7/8 22.00 Notch 2

1.0 26.00 Notch 4

1–3/16 32.00 Notch 6

• Reinstall the rubber actuator (1) in the storage compartment (7) by

twisting and pushing it back into the slot.

2005 Escape (204)

Owners Guide (post-2002-fmt)

USA_English (fus)

Driver Controls

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 295 296

Pas de commentaire

Ford 2005 Escape v.4 Manuel d'utilisateur Page 61