Ford 2004 Explorer v.2 Manuel d'utilisateur télécharger pdf (Page 261)

13. Maximum Permissible Inflation Pressure: Tire manufactures

maximum permissible pressure and/or the pressure at which the

maximum load can be carried by the tire. This pressure is normally

higher than the manufacturer’s recommended cold inflation pressure

which can be found on either the tire label or certification label which is

located on the structure by the trailing edge of the driver’s door or the

edge of the driver’s door. The cold inflation pressure should never be set

lower than the recommended pressure on the vehicle label.

Note: You may not find this information on all tires because it is not

required by federal law.

The tire suppliers may have additional markings, notes or warnings such

as standard load, radial tubeless, etc.

Additional information contained on the tire sidewall for “LT” type

tires

“LT” type tires have some additional

information than those of “P” type

tires; these differences are

described below:

1. LT: Indicates a tire, designated by

the Tire and Rim Association

(T&RA), that is intended for service

on light trucks.

2. Load Range/Load Inflation

Limits: Indicates the tires

load-carrying capabilities and its

inflation limits.

3. Maximum Load Dual kg (lbs.)

at kPa (psi) cold: Indicates the

maximum load and tire pressure

when the tire is used as a dual; a

dual is defined as when four tires are put on the rear axle (a total of six

or more tires on the vehicle).

4. Maximum Load Single kg (lbs.) at kPa (psi) cold: Indicates the

maximum load and tire pressure when the tire is used as a single; a

single is defined as when two tires (total) are put on the rear axle.

2004 Explorer (exp)

Owners Guide (post-2002-fmt)

USA English (fus)

Maintenance and Specifications

261

1 2 ... 256 257 258 259 260 261 262 263 264 265 266 ... 295 296

Pas de commentaire

Ford 2004 Explorer v.2 Manuel d'utilisateur Page 261