Ford 2004 Expedition v.2 Manuel d'utilisateur télécharger pdf (Page 145)

Please read and understand the entire procedure before you begin.

1. Insert the first previously

programmed coded key into the

ignition and turn the ignition from

the 1 (OFF/LOCK) to the 3 (ON)

position [maintain ignition in 3 (ON)

for at least three seconds, but no

more than ten seconds].

2. Turn ignition from 3 (ON) back to

the 1 (OFF/LOCK) position in order

to remove the first coded key from

the ignition.

3. Within ten seconds of removing the first coded key, insert the second

previously programmed coded key into the ignition and turn the ignition

from the 1 (OFF/LOCK) to the 3 (ON) position [maintain ignition in 3

(ON) for at least three seconds but no more than ten seconds].

4. Turn the ignition from the 3 (ON) back to 1 (OFF/LOCK) position in

order to remove the second coded key from the ignition.

5. Within 10 seconds of removing the second coded key, insert the new

unprogrammed key (new key/valet key) into the ignition and turn the

ignition from the 1 (OFF/LOCK) to the 3 (ON) position [maintain

ignition in 3 (ON) for at least three seconds, but no more than ten

seconds]. This step will program your new key to a coded key.

6. To program additional new unprogrammed key(s), repeat this

procedure from Step 1.

If successful, the new coded key(s) will start the vehicle’s engine and the

theft indicator will illuminate for three seconds and then go out.

If not successful, the new coded key(s) will not start the vehicle’s engine

and the theft indicator will flash on and off and you may repeat Steps 1

through 5. If failure repeats, bring your vehicle to your dealership to

have the new spare key(s) programmed.

2004 Expedition (exd)

Owners Guide (post-2002-fmt)

USA English (fus)

Locks and Security

145

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 351 352

Pas de commentaire

Ford 2004 Expedition v.2 Manuel d'utilisateur Page 145