Ford 2004 Expedition v.2 Manuel d'utilisateur télécharger pdf (Page 116)

device should activate when the HomeLink威 button is pressed and

released. Note: To program the remaining two HomeLink威 buttons,

begin with step 2 in the “Programming” section — do not repeat step 1.

Note: If the red light blinks rapidly for two seconds and then turns to a

continuous red, proceed with steps 6 through 8 to complete

programming of a rolling code equipped device.

6. At the garage door opener receiver (motor-head unit) in the garage,

locate the “learn” or “smart” button (usually near where the hanging

antenna wire is attached to the unit).

7. Press and release the “learn” or “smart” button. (The name and color

of the button may vary by manufacturer.)

Note: There are 30 seconds in which to initiate step eight.

8. Return to the vehicle and firmly press, hold for two seconds and

release the HomeLink威 button. Repeat the press/hold/release sequence

again, and, depending on the brand of the garage door opener (or other

rolling code equipped device), repeat this sequence a third time to

complete the programming.

HomeLink威 should now activate your rolling code equipped device. To

program additional HomeLink威 buttons begin with step 2 in the

“Programming” section. For questions or comments, please contact

HomeLink at www.homelink.com or 1–800–355–3515.

Gate Operator & Canadian Programming

During programming, your

hand-held transmitter may

automatically stop transmitting —

not allowing enough time for

HomeLink威 to accept the signal

from the hand-held transmitter.

After completing steps 1 and 2

outlined in the “Programming”

section, replace step 3 with the following:

Note: If programming a garage door opener or gate operator, it is

advised to unplug the device during the “cycling” process to prevent

overheating.

• Continue to press and hold the HomeLink威 button (note step 3 in the

“Programming” section) while you press and release — every two

seconds (“cycle”) your hand-held transmitter until the frequency

signal has been accepted by the HomeLink威. The red indicator light

will flash slowly and then rapidly after HomeLink威 accepts the radio

frequency signal.

2004 Expedition (exd)

Owners Guide (post-2002-fmt)

USA English (fus)

Driver Controls

116

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 351 352

Commentaires sur ces manuels

Pas de commentaire

Ford 2004 Expedition v.2 Manuel d'utilisateur Page 116

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2004 Expedition v.2