Ford 2003 Taurus v.2 Manuel d'utilisateur télécharger pdf (Page 67)

You may also perform the following power door lock sequence to

enable/disable the perimeter lamps feature:

1. Turn the ignition to ON, then press the power door unlock control 3

times.

2. Turn the ignition to OFF, then press the power door unlock control 3

times.

3. Turn the ignition to ON, and within five seconds press the power door

unlock control 2 times. Note: You will receive two horn chirps to

indicate that the system has been altered successfully.

4. Turn the ignition to the OFF position to exit the procedure.

Note:the puddle lamps cannot be deactivated; performing this procedure

will only deactivate the head, park and tail lamps.

KEYLESS ENTRY SYSTEM (IF EQUIPPED)

You can use the keyless entry

keypad to:

• lock or unlock the doors without

using a key.

• open the trunk.

• activate or deactivate the autolock feature.

The keypad can be operated with the factory set 5–digit entry code; this

code is located on the owner’s wallet card in the glove box, is marked on

the computer module, and is available from your authorized dealer. You

can also create your own 5–digit personal entry code.

When pressing the controls on the keypad, press the middle of the

controls to ensure a good activation.

Programming a personal entry code

To create your own personal entry code:

1. Enter the factory set code.

2. Within five seconds press the 1 • 2 on the keypad.

3. Enter your personal 5-digit code. Each number must be entered

within five seconds of each other.

Tips:

• Do not set a code that uses five of the same number.

• Do not use five numbers in sequential order.

1 2

45678

Locks and Security

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 215 216

Pas de commentaire

Ford 2003 Taurus v.2 Manuel d'utilisateur Page 67