Ford 2003 Taurus v.2 Manuel d'utilisateur télécharger pdf (Page 44)

Sedan

1. Make sure headlamp switch is in

OFF position and remove two

screws, grommets and the license

plate lamp assembly from the trunk

lid.

2. Carefully pull the bulb from the

socket and push in the new bulb.

3. Install the lamp assembly on

trunk lid with two grommets,

ensuring the grommets are pushed all the way in to the trunk lid and

secure with two screws.

Replacing tail/brake/turn signal/backup lamp bulbs

Sedan

The tail lamp, brake lamp, turn

signal lamp and backup lamp bulbs

are located in the same portion of

the tail lamp assembly. Follow the

same steps to replace either bulb.

1. Make sure headlamp switch is in

OFF position and open trunk and

remove two plastic mushroom nuts,

five push pins and the plastic cover

from inside the trunk to access the

lamp assembly.

2. Carefully pull the carpet away to

expose the lamp assembly hardware.

3. Remove three nut and washer

assemblies and the lamp assembly

from the vehicle.

4. Remove the bulb socket by

rotating it counterclockwise, then

pulling it out of the lamp assembly.

5. Pull the bulb from the socket and

push in the new bulb.

Lights

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 215 216

Pas de commentaire

Ford 2003 Taurus v.2 Manuel d'utilisateur Page 44