Ford 2003 Explorer v.2 Manuel d'utilisateur télécharger pdf (Page 81)

Memory seat feature (if equipped)

The remote entry system can also control the memory seat feature.

Press

to automatically move the seat to the desired memory position

(the seat position corresponds to the transmitter being used).

Activating the memory seat feature

To activate this feature:

1. Position the seat to the position you desire.

2. Press the SET control on the

driver’s door panel.

3. Within 5 five seconds, press one

control on the remote transmitter

and then press the 1 or 2 control on

the driver’s door panel to which you

would like to associate with the seat

and Driver 1 or Driver 2 positions.

4. Repeat this procedure for another

remote transmitter if desired.

Deactivating the memory seat feature

To deactivate this feature:

1. Press the SET control on the driver’s door panel.

2. Within 5 five seconds, press any control on the remote transmitter

which you would like to deactivate and then press the SET control on

the driver’s door panel.

3. Repeat this procedure for another remote transmitter if desired.

Replacing the battery

The remote entry transmitter uses one coin type three-volt lithium

battery CR2032 or equivalent. The typical operating range for your

remote entry transmitter is approximately 10 meters (33 feet). A

decrease in the operating range could be caused by:

• weather conditions,

• nearby radio towers,

• structures around the vehicle and

• other vehicles parked next to the vehicle.

SET

Locks and Security

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 279 280

Pas de commentaire

Ford 2003 Explorer v.2 Manuel d'utilisateur Page 81