Ford 2003 Explorer v.2 Manuel d'utilisateur télécharger pdf (Page 36)

Move the control to the full down position (past detent) to prevent

interior lamps from illuminating when the doors are opened.

AIMING THE HEADLAMPS

The headlamps on your vehicle are properly aimed before leaving the

assembly plant. If your vehicle is involved in an accident or if you have

problems fixing the alignment of your headlamps, have them checked by

a qualified service technician.

Headlamp aim adjustment

The headlamps on your vehicle can only be vertically adjusted. Your

vehicle does not require horizontal aim adjustments.

To adjust the headlamps:

1. Park your vehicle on a level

surface about 7.6 meters (25 feet)

away from a vertical plain surface

(3). Check your headlamp alignment

at night or in a dark area so that

you can see the headlamp beam

pattern.

• (1) Eight feet

• (2) Center height of lamp to

ground

• (3) Twenty-five feet

• (4) Horizontal reference line

2. The center of the headlamp has a 3.0 mm circle on the lens. Measure

the height from the center of your headlamp to the ground (2) and mark

a 2.4 meter (8 foot) long horizontal line on the plain surface (1) at this

height (masking tape works well).

3. Turn on the low beam headlamps.

The brightest part of the light

should be below the horizontal line

(4). If it is above the line the

headlamp will need to be adjusted.

4. Open the hood.

Lights

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 279 280

Pas de commentaire

Ford 2003 Explorer v.2 Manuel d'utilisateur Page 36