Ford 2002 Taurus v.1 Manuel d'utilisateur télécharger pdf (Page 60)

2. Install the bulb retaining ring over the plastic base and lock the ring

by rotating clockwise until it snaps into place.

3. Connect the electrical connector to the bulb.

4. Install the protective dust shield and lock the shield by rotating it

clockwise until it locks into position.

5. Carefully position the headlamp assembly onto the vehicle.

6. Hold the headlamp assembly snugly against the vehicle and install the

retainer pins straight down to lock the lamp into place.

7. Before reinstalling the bolt, make sure the retainer pins are fully

seated, and install bolt on headlamp housing.

8. Turn the headlamps on and make sure they work properly. If the

headlamp was correctly aligned before you changed the bulb, you should

not need to align it again.

Replacing front parking lamp/turn signal/cornering lamp bulbs

1. Make sure the headlamp control

is in the OFF position.

2. Remove the bolt from the

headlamp housing.

3. At the back of the headlamp, pry

up and remove the two retainer pins

to release the headlamp assembly

from the vehicle and pull headlamp

forward.

4. Rotate the bulb socket

counterclockwise and remove it

from the lamp assembly.

Lights

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 247 248

Pas de commentaire

Ford 2002 Taurus v.1 Manuel d'utilisateur Page 60