Ford 2002 E-450 v.2 Manuel d'utilisateur télécharger pdf (Page 175)

Model Bolt size Wheel lug nut torque*

Nm Lb-ft

E-150 1/2-20 135 100

E-250, E-350 and E-450 9/16-18 190 140

E-550 M14x1.5 200–225 150–165

* Torque specifications are for nut and bolt threads free of dirt and rust.

Do not use oil or grease on threads (E-550 vehicles, refer to following

Note). Use only Ford recommended replacement fasteners.

Note: For E-550 vehicles, on all

two-piece flat wheel nuts, apply

motor oil between the flat washer

and the nut. Do not apply motor oil

to the wheel nut threads or the

wheel stud threads.

JUMP STARTING YOUR VEHICLE

The gases around the battery can explode if exposed to flames,

sparks, or lit cigarettes. An explosion could result in injury or

vehicle damage.

Batteries contain sulfuric acid which can burn skin, eyes and

clothing, if contacted.

Do not attempt to push-start your vehicle. Automatic transmissions

do not have push-start capability; also, the catalytic converter may

become damaged.

Preparing your vehicle

When the battery is disconnected or a new battery is installed, the

transmission must relearn its shift strategy. As a result, the transmission

may have firm and/or soft shifts. This operation is considered normal and

will not affect function or durability of the transmission. Over time, the

adaptive learning process will fully update transmission operation.

1. Use only a 12–volt supply to start your vehicle.

2. Do not disconnect the battery of the disabled vehicle as this could

damage the vehicle’s electrical system.

Roadside Emergencies

175

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 255 256

Pas de commentaire

Ford 2002 E-450 v.2 Manuel d'utilisateur Page 175