Ford 2014 Fusion Hybrid v.2 Manuel d'utilisateur télécharger pdf (Page 71)

Note: Wet or winter driving conditions with

ice, snow or salty road mist can cause

inconsistent and unexpected wiping or

smearing.

In these conditions, you can do the

following to help keep your windshield

clear:

• Lower the sensitivity of the autowipers

to reduce the amount of smearing.

• Switch to normal or high-speed wipe.

• Switch the autowipers off.

A

C

B

E169315

Highest sensitivityA

OnB

Lowest sensitivityC

The autowipers feature uses a rain sensor.

You will find it in the area around the

interior mirror. The rain sensor monitors

the amount of moisture on the windshield

and automatically turns on the wipers. It

will adjust the wiper speed by the amount

of moisture that the sensor detects on the

windshield. You can turn this feature on

and off in the information display. See

General Information (page 88).

Use the rotary control to adjust the

sensitivity of the rain sensor. Set the

control to low sensitivity, and the wipers

will turn on when the rain sensor detects

a large amount of moisture on the

windshield. Set the control to high

sensitivity, and the wipers will turn on when

the rain sensor detects a small amount of

moisture on the windshield.

Keep the outside of the windshield clean.

The rain sensor is very sensitive. If the area

around the mirror is dirty, then the wipers

may operate if dirt, mist or insects hit the

windshield.

WINDSHIELD WASHERS

Note: Do not operate the washers when

the washer reservoir is empty. This may

cause the washer pump to overheat.

E169316

To operate the washers and spray the

windshield, pull the lever toward you.

A wipe will occur a few seconds after

washing to clear any remaining washer

fluid. This feature can be switched on or

off in the information display. See General

Information (page 88).

68

Fusion/Mondeo (CC7)

Wipers and Washers

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 477 478

Commentaires sur ces manuels

Pas de commentaire