Ford 2015 F-550 v.1 Manuel d'utilisateur télécharger pdf (Page 253)

E163824

10. For the park or turn lamp bulb,

remove the bulb by turning it

counterclockwise and pulling it

straight out.

11. Install the new bulb(s) in reverse

order.

CHANGING A BULB

Lamp Assembly Condensation

Exterior lamps are vented to

accommodate normal changes in pressure.

Condensation can be a natural by-product

of this design. When moist air enters the

lamp assembly through the vents, there is

a possibility that condensation can occur

when the temperature is cold. When

normal condensation occurs, a thin film of

mist can form on the interior of the lens.

The thin mist eventually clears and exits

through the vents during normal operation.

Clearing time may take as long as 48 hours

under dry weather conditions.

Examples of acceptable condensation are:

• Presence of thin mist (no streaks, drip

marks or droplets).

• Fine mist covers less than 50% of the

lens.

Examples of unacceptable moisture

(usually caused by a lamp water leak) are:

• Water puddle inside the lamp.

• Large water droplets, drip marks or

streaks present on the interior of the

lens.

Take your vehicle to a dealer for service if

any of the above conditions of

unacceptable moisture are present.

Replacing Front Clearance and

Identification Lamp Bulbs (If

Equipped)

E163825

1. Make sure the headlamps are off.

2. Remove the screw and lens from the

lamp assembly.

3. Separate the bulb from the bulb

socket.

4. Install the new bulb in reverse order.

250

Super Duty (), enUSA

Maintenance

1 2 ... 248 249 250 251 252 253 254 255 256 257 258 ... 469 470

Commentaires sur ces manuels

Pas de commentaire