Ford 2015 F-550 v.1 Manuel d'utilisateur télécharger pdf (Page 62)

1. Insert the first previously programmed

coded key into the ignition.

2. Switch the ignition from off to on. Keep

the ignition on for at least three

seconds, but no more than 10 seconds.

3. Switch the ignition off and remove the

first coded key from the ignition.

4. After three seconds but within 10

seconds of switching the ignition off,

insert the second previously coded key

into the ignition.

5. Switch the ignition from off to on. Keep

the ignition on for at least three

seconds, but no more than 10 seconds.

6. Switch the ignition off and remove the

second previously programmed coded

key from the ignition.

7. After three seconds but within 10

seconds of switching the ignition off

and removing the previously

programmed coded key, insert the new

unprogrammed key into the ignition.

8. Switch the ignition from off to on. Keep

the ignition on for at least six seconds

until you hear the door locks cycle.

9. Remove the newly programmed coded

key from the ignition.

The key will start the engine if

programming is successful. You can

operate the remote entry system if the new

key is an integrated keyhead transmitter.

If programming was not successful, wait

20 seconds and repeat Steps 1 through 8.

If you are still unsuccessful, take your

vehicle to an authorized dealer.

ANTI-THEFT ALARM (IF EQUIPPED)

The system warns you of an unauthorized

entry to your vehicle. It triggers if any door

or the hood opens without using the key,

remote control or keyless entry keypad.

The direction indicators flash and the horn

sounds if the system triggers while the

alarm is armed.

Take all remote controls to an authorized

dealer if there is any potential alarm

problem with your vehicle.

Arming the Alarm

The alarm is ready to arm when there is

not a key in the ignition. Electronically lock

the vehicle to arm the alarm.

The direction indicators flash once after

you lock the vehicle. This indicates the

alarm is in the pre-armed mode. It will fully

arm in 20 seconds.

Disarming the Alarm

Disarm the alarm by any of the following

actions:

• Press the power door unlock button

within the 20-second pre-armed mode.

• Unlock the doors with the remote

control or keyless entry keypad.

• Switch the ignition on or start the

vehicle.

• Use a key in the driver door to unlock

the vehicle, then switch the ignition on

within 12 seconds.

Note: Pressing the panic button on the

remote control will stop the horn and signal

indicators, but will not disarm the system.

59

Super Duty (), enUSA

Security

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 469 470

Commentaires sur ces manuels

Pas de commentaire