Ford 2015 F-550 v.1 Manuel d'utilisateur télécharger pdf (Page 290)

• To reduce the chances of interference

from another vehicle, perform the

system reset procedure at least three

feet (one meter) away from another

Ford Motor Company vehicle

undergoing the system reset procedure

at the same time.

• Do not wait more than two minutes

between resetting each tire sensor or

the system will time-out and the entire

procedure will have to be repeated on

all four wheels.

• A double horn will sound indicating the

need to repeat the procedure.

Performing the System Reset Procedure

Read the entire procedure before

attempting.

1. Drive the vehicle above 20 mph (32

km/h) for at least two minutes, then

park in a safe location where you can

easily get to all four tires and have

access to an air pump.

2. Place the ignition in the off position and

keep the key in the ignition.

3. Cycle the ignition to the on position

with the engine off.

4. Turn the hazard flashers on then off

three times. You must accomplish this

within 10 seconds. If the reset mode

has been entered successfully, the horn

will sound once, the system indicator

will flash and a message is shown in

the information display. If this does not

occur, please try again starting at Step

2. If after repeated attempts to enter

the reset mode, the horn does not

sound, the system indicator does not

flash and no message is shown in the

information display, seek service from

your authorized dealer.

5. Train the tire pressure monitoring

system sensors in the tires using the

following system reset sequence

starting with the left front tire in the

following clockwise order: Left front

(driver's side front tire), Right front

(passenger's side front tire), Right rear

(passenger's side rear tire), Left rear

(driver's side rear tire)

6. Remove the valve cap from the valve

stem on the left front tire. Decrease the

air pressure until the horn sounds.

Note: The single horn chirp confirms

that the sensor identification code has

been learned by the module for this

position. If a double horn is heard, the

reset procedure was unsuccessful, and

you must repeat it.

7. Remove the valve cap from the valve

stem on the right front tire. Decrease

the air pressure until the horn sounds.

8. Remove the valve cap from the valve

stem on the right rear tire. Decrease the

air pressure until the horn sounds.

9. Remove the valve cap from the valve

stem on the left rear tire. Decrease the

air pressure until the horn sounds.

Training is complete after the horn

sounds for the last tire trained (driver's

side rear tire), the system indicator

stops flashing, and a message is shown

in the information display.

10. Turn the ignition off. If two short horn

beeps are heard, the reset procedure

was unsuccessful and you must

repeat it. If after repeating the

procedure and two short beeps are

heard when the ignition is turned to

off, seek assistance from your

authorized dealer.

287

Super Duty (), enUSA

Wheels and Tires

1 2 ... 285 286 287 288 289 290 291 292 293 294 295 ... 469 470

Commentaires sur ces manuels

Pas de commentaire