Ford 2015 F-550 v.1 Manuel d'utilisateur télécharger pdf (Page 126)

To program another rolling code device,

repeat Steps 1 through 6, substituting a

different function button in Step 5.

Fixed Code Programming

Note: It may be helpful to have another

person assist you in programming the

transmitter.

To program units with fixed code DIP

switches, you will need the garage door

hand-held transmitter, paper and a pen or

pencil.

1. Switch the ignition on.

2. Open the battery cover and note all the

switch settings from left to right.

E164778

• When the switch is in the up, on, or +

position, mark down “left button”.

• When the switch is in the middle,

neutral, or 0 position, mark down

“middle button”.

• When the switch is in the down, off, or

– position, mark down “right button”.

3. Press all three function buttons

simultaneously for a few seconds and then

release. The LED lamps will flash slowly.

E164776

Note: You must complete the following

step within 2.5 minutes.

4. Enter the corresponding DIP switch

settings from left to right into the system

by pressing and releasing the buttons

corresponding to the settings you noted.

5. Simultaneously press and release all

three function buttons. The LED lamps will

illuminate.

E164776

6. Press and hold the function button you

would like to use to control the garage

door.

Note: You may need to hold the button

from 5–55 seconds before observing

movement of the garage door.

7. When the garage door moves, release

the button within one second. After you

release the button, the LED lamp will flash

slowly.

8. The LED lamp will begin to flash rapidly

until programming is complete. If your

garage door does not operate, repeat the

previous steps. Otherwise, call the toll-free

help line at 1-866-572-2728.

The LED lamp above the selected button

will illuminate to confirm that the system

is responding to the button command.

Erasing the Function Button Codes

Note: You cannot erase individual buttons.

1. Press and hold the outer two function

buttons simultaneously for approximately

20 seconds until the LED lamps above the

buttons flash rapidly

123

Super Duty (), enUSA

Universal Garage Door Opener (If Equipped)

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 469 470

Commentaires sur ces manuels

Pas de commentaire