Ford 2014 F-150 Raptor v.2 Manuel d'utilisateur télécharger pdf (Page 156)

E166931

2H (4X2)

For general on-road driving. Sends power

to the rear wheels only and should be used

for street and highway driving. Provides

optimal smoothness and fuel economy at

high speeds.

4A (4X4 AUTO)

Provides electronic control four-wheel

drive with power delivered to the front and

rear wheels, as required, for increased

traction. This is appropriate for all on-road

driving conditions, including as dry road

surfaces, but is especially useful on wet

pavement, snow, dirt, or gravel.

4H (4X4 HIGH)

Used for extra traction such as in snow or

icy roads or in off road situations. This

mode is not intended for use on dry

pavement.

Note: Do not use 4H (4X4 HIGH) on dry,

hard surfaced roads. Doing so can produce

excessive noise and increased tire wear. 4H

(4X4 HIGH) is only intended for consistently

slippery or loose surfaces.

4L (4X4 LOW)

Uses extra gearing to provide maximum

power to all four wheels at reduced

speeds. Intended only for off-road

applications such as deep sand, steep

grades, or pulling heavy objects. 4L (4x4

low) will not engage while the vehicle is

moving above 3 mph (5 km/h); this is

normal and should be no reason for

concern. Refer to Shifting to or from 4L

(4x4 low) for proper operation.

Shifting between system modes

Note: Momentarily releasing the accelerator

pedal while performing a shift will improve

engagement/disengagement times.

Note: Do not perform this operation if the

rear wheels are slipping.

Note: Some noise may be heard as the

system shifts or engages; this is normal.

Note: 4X4 high mode is not intended for

use on dry pavement.

You can move the control from 2H to 4A

or 4H at a stop or while driving. The

information display may display a message

indicating a 4X4 shift is in progress. Once

the shift is complete the message center

will then display the system mode

selected.

Shifting to or from 4L (4X4 low)

Note: Some noise may be heard as the

system shifts or engages; this is normal.

Note: 4x4 low mode is not intended for use

on dry pavement.

1. Bring the vehicle to a speed of 3 mph

(5 km/h) or less.

2. Place the transmission in N (Neutral).

3. Move the 4WD control to the desired

position.

153

F150 (TF6) , enUSA

Four-Wheel Drive (If Equipped)

1 2 ... 151 152 153 154 155 156 157 158 159 160 161 ... 469 470

Commentaires sur ces manuels

Pas de commentaire