Ford 2014 F-150 Raptor v.2 Manuel d'utilisateur télécharger pdf (Page 152)

Column-shifter

1. Apply the parking brake. Turn the

ignition key to the off position, then

remove the key.

2. Move the steering column to the full

down and full rearward position

(toward the driver’s seat).

3. Remove the gearshift lever boot.

4. Place fingers into hole where the

gearshift lever boot was removed from

and pull top half of shroud up and

forward to separate it from the lower

half of the shroud. There is a hinge at

the forward edge of the top shroud.

Roll the top half of the shroud upward

on the hinge point to clear the hazard

flasher button, then pull straight

rearward toward the driver’s seat to

remove.

5. Remove the top half of the shroud.

6. Remove the three fasteners under the

column that secure the lower shroud

half to the column.

E163185

7. Pull the lock lever into the full unlocked

position and remove the lower shroud

cover by pulling the lever handle

through the slot in the cover.

E163186

8. Apply the brake and move the gearshift

lever into N (Neutral).

9. Start the vehicle.

Perform Steps 4 through 8 in reverse order,

making sure to engage the hinge pivots

between the upper and lower halves of the

shroud. Keep slight pressure in the forward

direction as the halves are rotated

together.

Floor-shifter

1. Apply the parking brake. Turn the

ignition key to the off position, then

remove the key.

2. Starting at the rear of the trim panel,

using a screwdriver (or similar tool)

carefully pry up the trim panel from

rear attachments and disconnect it

from the console to expose the inside

of the gearshift.

E166929

149

F150 (TF6) , enUSA

Transmission

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 469 470

Commentaires sur ces manuels

Pas de commentaire