Ford 2014 F-150 Raptor v.2 Manuel d'utilisateur télécharger pdf (Page 286)

when the low tire pressure telltale

illuminates, you should stop and check

your tires as soon as possible, and inflate

them to the proper pressure. Driving on a

significantly under-inflated tire causes the

tire to overheat and can lead to tire failure.

Under-inflation also reduces fuel efficiency

and tire tread life, and may affect the

vehicle’s handling and stopping ability.

Please note that the TPMS is not a

substitute for proper tire maintenance, and

it is the driver’s responsibility to maintain

correct tire pressure, even if under-inflation

has not reached the level to trigger

illumination of the TPMS low tire pressure

telltale.

Your vehicle has also been equipped with

a TPMS malfunction indicator to indicate

when the system is not operating properly.

The TPMS malfunction indicator is

combined with the low tire pressure

telltale. When the system detects a

malfunction, the telltale will flash for

approximately one minute and then remain

continuously illuminated. This sequence

will continue upon subsequent vehicle

start-ups as long as the malfunction exists.

When the malfunction indicator is

illuminated, the system may not be able

to detect or signal low tire pressure as

intended. TPMS malfunctions may occur

for a variety of reasons, including the

installation of replacement or alternate

tires or wheels on the vehicle that prevent

the TPMS from functioning properly.

Always check the TPMS malfunction

telltale after replacing one or more tires or

wheels on your vehicle to ensure that the

replacement or alternate tires and wheels

allow the TPMS to continue to function

properly.

The tire pressure monitoring system

complies with part 15 of the FCC rules and

with RSS-210 of Industry Canada.

Operation is subject to the following two

conditions: (1) This device may not cause

harmful interference, and (2) This device

must accept any interference received,

including interference that may cause

undesired operation.

Changing Tires With a Tire

Pressure Monitoring System

E142549

Note: Each road tire is equipped with a tire

pressure sensor located inside the wheel

and tire assembly cavity. The pressure

sensor is attached to the valve stem. The

pressure sensor is covered by the tire and is

not visible unless the tire is removed. Take

care when changing the tire to avoid

damaging the sensor

You should always have your tires serviced

by an authorized dealer.

Check the tire pressure periodically (at

least monthly) using an accurate tire

gauge. See Inflating Your Tires in this

chapter.

283

F150 (TF6) , enUSA

Wheels and Tires

1 2 ... 281 282 283 284 285 286 287 288 289 290 291 ... 469 470

Commentaires sur ces manuels

Pas de commentaire