Ford 2011 Mustang v.2 Manuel d'utilisateur télécharger pdf (Page 276)

6. Wipe the dipstick clean. Insert the dipstick fully, then remove it again.

• If the oil level is between the lower and upper holes, the oil level

is acceptable. DO NOT ADD OIL.

• If the oil level is below the lower hole, add enough oil to raise the

level within the lower and upper holes.

• Oil levels above the upper hole may cause engine damage. Some oil

must be removed from the engine by an authorized dealer.

7. Put the dipstick back in and ensure it is fully seated.

Adding engine oil

1. Check the engine oil. For instructions, refer to Checking the engine

oil in this chapter.

2. If the engine oil level is not within the normal range, add only certified

engine oil of the recommended viscosity. Remove the engine oil filler cap

and use a funnel to pour the engine oil into the opening.

3. Recheck the engine oil level. Make sure the oil level is not above the

normal operating range on the engine oil level dipstick.

4. Install the dipstick and ensure it is fully seated.

5. Fully install the engine oil filler cap by turning the filler cap clockwise

1/4 of a turn until three clicks are heard or until the cap is fully seated.

To avoid possible oil loss, DO NOT operate the vehicle with the

engine oil level dipstick and/or the engine oil filler cap removed.

Engine oil and filter recommendations

Look for this certification

trademark.

Maintenance and Specifications

276

2011 05+ Mustang (197)

Owners Guide, 2nd Printing

USA (fus)

1 2 ... 271 272 273 274 275 276 277 278 279 280 281 ... 345 346

Pas de commentaire

Ford 2011 Mustang v.2 Manuel d'utilisateur Page 276