Ford 2011 Edge v.3 Manuel d'utilisateur télécharger pdf (Page 140)

Note: A maximum of four intelligent access keys can be programmed to

your vehicle. If you would like to replace a previously programmed

access key with a new access key, or if you already have four access keys

programmed to your vehicle, you must take your vehicle and all access

keys to your authorized dealer to be erased and reprogrammed.

Ensure that the vehicle is off before beginning this procedure. Ensure

that all doors are closed before beginning this procedure and that all

doors remain closed throughout the procedure. Perform this procedure

exactly as described below, and perform all steps within 30 seconds of

starting the sequence. If any steps are performed out of sequence, stop

and wait for at least one minute before starting again.

Please read and understand the entire procedure before you begin.

1. Place the new unprogrammed intelligent access key in the pocket

inside of the center console.

2. Press the driver or passenger power door unlock control three times.

3. Press and release the brake pedal one time.

4. Press the driver or passenger power door lock control three times.

5. Press and release the brake pedal one time. The indicator on the

Start/Stop button should begin to rapidly flash, indicating that

programming mode has been entered and two programmed intelligent

access keys have been detected in the vehicle.

6. Within one minute, press the start/stop button. A message will be

displayed on the message center indicating that the new intelligent

access key was programmed. If four intelligent access keys have already

been programmed to your vehicle, you cannot program anymore and the

message MAX # OF KEYS LEARNED will be displayed on the message

center.

7. Remove the intelligent access key from the center console pocket and

press the

control on the newly programmed intelligent access keys to

exit programming mode.

8. Verify that the remote entry functions operate (press lock then

unlock, making sure you end in unlock) and that the vehicle starts with

new intelligent access key.

If the intelligent access key has been successfully programmed, it can be

used to activate the intelligent access with push button Start feature and

can be used to start your vehicle.

Note: To program MyKey威 features, refer to MyKey威 in this chapter.

Locks and Security

140

2011 Edge (edg)

Owners Guide, 3rd Printing

USA (fus)

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 395 396

Commentaires sur ces manuels

Pas de commentaire

Ford 2011 Edge v.3 Manuel d'utilisateur Page 140

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2011 Edge v.3