Ford 2010 F-550 v.2 Manuel d'utilisateur télécharger pdf (Page 366)

When the engine is cold, check the

level of the engine coolant in the

reservoir.

• The engine coolant should be at the FULL COLD level or within the

COLD FILL RANGE as listed on the engine coolant reservoir

(depending upon application).

• Refer to scheduled maintenance information for service interval

schedules.

If the engine coolant has not been checked at the recommended interval,

the engine coolant reservoir may become low or empty. If the reservoir is

low or empty, add engine coolant to the reservoir. Refer to Adding

engine coolant in this chapter.

Note: Automotive fluids are not interchangeable; do not use engine

coolant/antifreeze or windshield washer fluid outside of its specified

function and vehicle location.

Adding engine coolant

When adding coolant, make sure it is a 50/50 mixture of engine coolant

and distilled water. Add the mixture to the coolant reservoir, when the

engine is cool, until the appropriate fill level is obtained. If coolant is

filled to the COLD FILL RANGE or FULL COLD level when the engine is

not cool, the system will remain underfilled.

WARNING: Do not add engine coolant when the engine is hot.

Steam and scalding liquids released from a hot cooling system

can burn you badly. Also, you can be burned if you spill coolant on hot

engine parts.

WARNING: Do not put engine coolant in the windshield washer

fluid container. If sprayed on the windshield, engine coolant

could make it difficult to see through the windshield.

• DO NOT MIX different colors or types of coolant in your vehicle.

Make sure the correct coolant is used. DO NOT MIX recycled coolant

Maintenance and Specifications

366

2010 F-250/350/450/550 (f23)

Owners Guide, 2nd Printing

USA (fus)

1 2 ... 361 362 363 364 365 366 367 368 369 370 371 ... 407 408

Pas de commentaire

Ford 2010 F-550 v.2 Manuel d'utilisateur Page 366