Ford 2010 Escape v.1 Manuel d'utilisateur télécharger pdf (Page 107)

Note: The MyKey™ can be cleared within the same key cycle that it was

created, otherwise a standard key (Administrator key) is required to

disable the MyKey™ programming. To clear all MyKeys™ go to step 2 in

the Disable MyKey™ section.

Programming MyKey™ Optional Settings

Turn the ignition on using an Admin key. To program the optional

settings, use the message center buttons to do the following:

1. Press SETUP until RESET FOR MYKEY SETUP is displayed.

2. Press and release the RESET button to display MyKey™ setup menus.

The first menu shown is:

MYKEY MAX MPH <80 MPH> OFF

3. If you don’t want to change the maximum speed setting, press the

SETUP button to display the next menu. The remaining menus appear as

follows with the default settings shown:

MYKEY MPH TONES 45 55 65 <OFF>

MYKEY VOLUME LIMIT <ON> OFF

MYKEY ADVTRAC CTRL ON <OFF>.

4. On any of the menus press RESET to highlight your choice with the

<…>.

5. Press SETUP to enter your choice. The next optional setting will be

displayed.

6. Repeat steps 4 and 5 until you are done changing the optional

settings.

Disable MyKey™

To reset all MyKeys™ as Admin keys do the following:

1. Turn the vehicle on using the Admin key.

2. Press SETUP until PRESS RESET TO CLEAR MYKEY is displayed.

3. Press and release the RESET button. HOLD RESET TO CONFIRM

CLEAR is displayed.

4. Press and hold the RESET button for two seconds until ALL MYKEYS

CLEARED is displayed.

Check MyKey™ System Status

The vehicle System Check will provide the status of the following

MyKey™ parameters:

• MYKEY MILES — This odometer only tracks mileage when a MyKey™

is used. If mileage does not accumulate as expected, then the

Locks and Security

107

2010 Escape (204)

Owners Guide, 1st Printing

USA (fus)

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 344 345

Pas de commentaire

Ford 2010 Escape v.1 Manuel d'utilisateur Page 107