Ford 2007 Fusion v.1 Manuel d'utilisateur télécharger pdf (Page 93)

Replacing the battery

The Integrated Keyhead Transmitter uses one coin type three-volt

lithium battery CR2032 or equivalent.

To replace the battery:

1. Twist a thin coin in the slot of the

IKT near the key ring in order to

remove the battery cover.

2. Do not wipe off any grease on the

battery terminals on the back

surface of the circuit board.

3. Remove the old battery. Note: Please refer to local regulations when

disposing of transmitter batteries.

4. Insert the new battery. Refer to the instructions inside the IKT for the

correct orientation of the battery. Press the battery down to ensure that

the battery is fully seated in the battery housing cavity.

5. Snap the battery cover back onto the key.

Note: Replacement of the battery will not cause the IKT to become

deprogrammed from your vehicle. The IKT should operate normally after

battery replacement.

Replacing lost Integrated Keyhead Transmitters (IKTs)

If you would like to have your Integrated Keyhead Transmitters

reprogrammed because you lost one, or would like to buy additional

IKTs, you can either reprogram them yourself, or take all IKTs to your

authorized dealer for reprogramming.

How to reprogram your Integrated Keyhead Transmitters (IKTs)

To program a new Integrated Keyhead Transmitter yourself, refer to

Programming spare keys in the SecuriLock娂 passive anti-theft

section of this chapter. Note: At least two IKTs are required to perform

this procedure yourself.

2007 Fusion (fsn)

Owners Guide (post-2002-fmt)

USA (fus)

Locks and Security

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 279 280

Pas de commentaire

Ford 2007 Fusion v.1 Manuel d'utilisateur Page 93