Ford 2005 Explorer v.2 Manuel d'utilisateur télécharger pdf (Page 136)

1. Turn the ignition switch to the RUN (or ON) position. (DO NOT

START THE ENGINE)

2. Wait until the safety belt warning light turns off. (Approximately 1–2

minutes)

• Steps 3–5 must be completed within 60 seconds or the procedure will

have to be repeated.

3. At a moderate speed, buckle then unbuckle the safety belt three

times, ending with the safety belt unbuckled. This can be done before or

during BeltMinder娂 warning activation.

4. Turn on the parklamps/headlamps, turn off the parklamps/headlamps.

5. At a moderate speed, buckle then unbuckle the safety belt three

times, ending with the safety belt unbuckled.

• After Step 5 the safety belt warning light will be turned on for three

seconds.

6. Within seven seconds of the safety belt warning light turning off, at a

moderate speed, buckle then unbuckle the safety belt.

• This will disable BeltMinder娂 if it is currently enabled, or enable

BeltMinder娂 if it is currently disabled.

7. Confirmation of disabling BeltMinder娂 is provided by flashing the

safety belt warning light four times per second for three seconds.

8. Confirmation of enabling BeltMinder娂 is provided by flashing the

safety belt warning light four times per second for three seconds,

followed by three seconds with the safety belt warning light off, then

followed by flashing the safety belt warning light four times per second

for three seconds again.

9. After receiving confirmation, the deactivation/activation procedure is

complete.

Safety belt maintenance

Inspect the safety belt systems periodically to make sure they work

properly and are not damaged. Inspect the safety belts to make sure

there are no nicks, tears or cuts. Replace if necessary. All safety belt

assemblies, including retractors, buckles, front safety belt buckle

assemblies, buckle support assemblies (slide bar-if equipped), shoulder

belt height adjusters (if equipped), shoulder belt guide on seatback (if

equipped), child safety seat LATCH and tether anchors, and attaching

hardware, should be inspected after a collision. Ford Motor Company

recommends that all safety belt assemblies in use in vehicles involved in

2005 Explorer (exp)

Owners Guide (post-2002-fmt)

USA_English (fus)

Seating and Safety Restraints

136

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 319 320

Pas de commentaire

Ford 2005 Explorer v.2 Manuel d'utilisateur Page 136