Ford 2005 Explorer v.2 Manuel d'utilisateur télécharger pdf (Page 108)

When pressing the controls on the keypad, press the middle of the

controls to ensure a good activation.

Programming a personal entry code

To create your own personal entry code:

1. Enter the factory set code.

2. Within five seconds press the 1 • 2 on the keypad.

3. Enter your personal 5-digit code. Each number must be entered

within five seconds of each other.

4. The doors will again lock then unlock to confirm that your personal

keycode has been programmed to the module.

Tips:

• Do not set a code that uses five of the same number.

• Do not use five numbers in sequential order.

• The factory set code will work even if you have set your own personal

code.

• If you set a second personal code it will erase your first personal code.

Erasing personal code

1. Enter the factory set 5–digit code.

2. Within five seconds, press the 1 • 2 on the keypad and release.

3. Press and hold the 1 • 2 for two seconds. This must be done within

five seconds of completing Step 2.

Your personal code is now erased and only the factory set 5–digit code

will work.

Anti-scan feature

If the wrong code has been entered 7 times (35 consecutive button

presses), the keypad will go into an anti-scan mode. This mode disables

the keypad for one minute and the keypad lamp will flash.

The anti-scan feature will turn off after:

• one minute of keypad inactivity.

• pressing the UNLOCK

control on the remote entry transmitter.

• the ignition is turned to the 3 (ON) position.

2005 Explorer (exp)

Owners Guide (post-2002-fmt)

USA_English (fus)

Locks and Security

108

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 319 320

Pas de commentaire

Ford 2005 Explorer v.2 Manuel d'utilisateur Page 108